Delonghi AC Error Codes

AC BrandsDelonghi

Delonghi Portable AC Error Codes

Error CodesProblem
LELow Temperature (frost prevention). The appliance is fitted with a frost protection device to avoid excessive formation of ice. The appliance starts up again automatically when the defrosting process is completed.
HLHigh Level (internal tray full). Empty the internal safety tray following the instructions in the section “End of season operations”. If it reoccurs in cooling mode, contact your local authorised customer services. In heating mode: empty the internal tray.
CFChange filter. When this message is displayed, the water filter needs replacing as described in the section: “Replacing the limescale filter”.
PFProbe Failure (sensor damaged). If this is displayed, contact your local authorised service centre.
F1Failure 1. This message could appear if the water filter is particularly clogged. See section: “Replacing the limescale filter”. If the filter has been replaced recently, contact your local authorised service centre.
LoLow Temperature - Room temperature is too low.
H1High Temperature - Room temperature is too high.
E1Probe Failure ( Sensor Damaged).

The appliance has a self diagnosis system to identify a number of malfunctions. Error messages are displayed on the appliance display.

After that you can easily download our mobile application and search all delonghi ac error codes and also search other world wide brands error codes complete lists.

Delonghi Portable Air Conditioner Error Codes – LE HL CF PF F1

Troubleshooting

Problem: The air conditioner does not come on

Cause:

  1. there is no current
  2. Check the power maybe main switch not turned on
  3. the internal safety device has tripped

Solution:

  1. wait
  2. plug into the mains
  3. call the Service Centre

Problem: The air conditioner works for a short time only

Cause:

  1. there are bends or kinks in the air exhaust hose
  2. something is preventing the air from being discharged

Solution:

  1. position the air hose correctly, keeping it as short and free of curves as possible to avoid bottlenecks.
  2. check and remove any obstacles obstructing air discharge

Problem: The air conditioner works, but does not cool the room

Cause:

  1. windows, doors and/or curtains open
  2. there are heat sources in the room (oven, hairdryer, etc)
  3. the air exhaust hose is detached from the appliance
  4. dust filters clogged

Solution:

  1. close doors, windows and curtains, bearing in mind the “tips for correct use” given above
  2. eliminate the heat sources
  3. fit the air exhaust hose in the housing at the back of the appliance
  4. clean or replace the filters as described above

Problem: During operation, there is an unpleasant smell in the room

Cause: dust filter and (when present) electrostatic filter clogged

Solution: clean the filters as described above

Problem: The air conditioner does not operate for about three minutes after restarting it

Cause: the internal compressor safety device prevents the appliance from being restarted until three minutes have elapsed since it was last turned off.

Solution: wait. This delay is part of normal operation.

Problem: The symbol and one of the following messages LT / HL/Cf/PF / FI appears on the appliance display:

Cause: The appliance has a self diagnosis system to identify a number of malfunctions.

 

Leave a Reply

Your email address will not be published. Required fields are marked *

Fill out this field
Fill out this field
Please enter a valid email address.
You need to agree with the terms to proceed

You May Also Like

derby ac error codes
Derby AC Error Codes
danby ac error codes
Danby AC Error Codes

Subscribe to our Youtube Channel

Must Read

Menu